Glass steel grille used in many cases will inevitably have to cut the new assembly, the ideal situation is of course the whole plate can be spliced, and whole plate cutting is also good, but sometimes there are some special size will have a certain material loss.
frp grating
The problem is that we do not want to see, because the material loss will increase the cost, so how to control the loss of material damage is the place where we need to pay attention to. The following examples are used to introduce the glass fiber reinforced plastic grating cutting and splicing.
General car parking spaces are 2.44*4.88m, so you can directly use the 1.22*2.44m four board splicing on it. The road on both sides of the hole is usually the size of the 1*1m, the whole plate and can be used directly 1*4m into four pieces to meet use.
Of course, this is the ideal situation, before the customer requires the use of 1.1*1.1m pits, at this time it is necessary to cut material loss. If the whole board uses 1.22*3.66m 0.12M to cut the width, length to cut 0.36M, in this way, the whole material loss is very large.
So in order to communicate before and manufacturers, set a reasonable size, sometimes some special size can also require manufacturers to board production, these are less or even no fundamental channel material loss. |
